American Printer's mission is to be the most reliable and authoritative source of information on integrating tomorrow's technology with today's management.

What causes doubling on press?

Mar 1, 2007 12:00 AM


         Subscribe in NewsGator Online   Subscribe in Bloglines

TECH THOUGHT #3

When looking through a 100x glass or microscope, a double will show itself rather prominently in the 15 percent to 25 percent dots. It will show as a light dot beside or overlapping a strong dot.

Two sheetfed causes
Doubling can occur two ways on a sheetfed press. The first is premature contact with a blanket—normally on the first unit of the press—caused by stiff paper or board slapping the blanket. The second cause is unit-to-unit misregister caused by poor gripper timing or setting, worn grippers, dirty grippers, worn cam followers, wavy paper and so on. The net result is severe color variation even though density is being held to the best of the press and operator’s abilities.

Web press woes
On web presses, the problem can be related to stock, roll condition, tilt boxes not working properly, and press out of tram, tension problems. Keep in mind: The longer the press and the heavier the stock, the more difficult it is to print without doubles.

The problem with doubling is that it is easy to state the problem, more difficult to identify the cause and expensive to eliminate. When purchasing a new or used press, test it thoroughly prior to installation.